ZMQ SUB Source

Receive messages on ZMQ SUB socket and source stream.

This block will connect to a ZMQ PUB socket, then produce all incoming messages as streaming output.

Parameters

(R): Run-time adjustable

Address

ZMQ socket address specifier. The format of the address is tcp://*:port where * should be 127.0.0.1 for localhost.

Note: If the Source and Sink blocks are on two different computers on the same LAN, then the IP and port number of the Sink block must be specified on each end of that connection. For example, if the Sink is on IP 192.168.2.14:5678 and the Source is on IP 192.168.2.5, both Source and Sink blocks must specify the Sink IP and port (192.168.2.14:5678).

WARNING: ZMQ endpoints look like URLs but they are not. A "tcp" endpoint specifies an IP address or a network adapter (e.g., lo or eth0). Do not use hostnames, like "localhost".

Timeout

Receive timeout in milliseconds, default is 100ms.

Pass Tags

Whether source will look for and deserialize tags.

Hign Watermark

High Watermark to configure the socket to (-1 => zmq's default)

Example Flowgraph

This is a flowgraph of an Amplitude Modulation receiver. The signal from the transmitter section is received by the ZMQ SUB Source. It is a 48khz carrier with a sample rate of 768khz. For complete details, see Simulation_example:_AM_transmitter_and_receiver#AM_receiver.

Source Files

C++ files

TODO

Header files

TODO

Public header files

TODO

Block definition

TODO