GFSK Mod: Difference between revisions

From GNU Radio
Jump to navigation Jump to search
Line 19: Line 19:


; Verbose
; Verbose
: Print information about modulator?
: Prints the value of bits per symbol and BT
: Default value = Off
: Default value = Off



Revision as of 06:15, 22 December 2021

Hierarchical block for Gaussian Frequency Shift Key (GFSK) modulation.

The input is a byte stream (unsigned char) and the output is the complex modulated signal at baseband.

Parameters

Samples/Symbol
Samples per baud >= 2 (integer)
Default value = 2
Sensitivity
Given to the Frequency Mod
Default value = 1.0
BT
Gaussian filter bandwidth * symbol time (float)
Default value = 0.35
Verbose
Prints the value of bits per symbol and BT
Default value = Off
Log
Print modulation data to files?
Default value = Off
Unpack (depreciated in GNU Radio 3.8)
Unpack input byte stream?

Example Flowgraph

The flowgraph below shows an example of the GFSK Mod and GFSK Demod blocks in action. We GFSK modulate 9-bit long bit stream '000111011', and then GFSK demodulate it. Then we compare the two bit streams to make sure that they are the same.

Gfsk mod and demod.png

When the flowgraph runs, we see that the red and blue signals are the same, meaning that the bit streams before and after the GFSK modulation and demodulation are the same.

In order to replicate the results shown below, make sure you do the following:

  1. Make sure you have a vector of 9 bits in your vector source. For example, I used (0,0,0,1,1,1,0,1,1) in this example.
  2. Make sure you turn off the unpack function in the GFSK Mod block. You will need to double click the block to bring up the Properties pop-up in order to turn it off. Turn it off. Then you will see "Unpack: Off" show up on the block after you close its Properties pop-up.

Gfsk mod and demod in action.png

Source Files

Python files
[1]
Block definition
[2]