HardwareTransceiver: Difference between revisions

From GNU Radio
Jump to navigation Jump to search
(Imported from Redmine)
 
No edit summary
Line 11: Line 11:
== Transmitter activation (PTT switches, etc) ==
== Transmitter activation (PTT switches, etc) ==


See the [[TransmitterActivation]] page for advice about PTT microphone switches, foot-switches, etc
When building a transmitter or transceiver, there are various ways to start and stop transmission.
 
* always on - as long as the application is running, transmission occurs continuously.
* widget - using the mouse or keyboard to control a widget on the user interface
* USB microphone with PTT switch - this may be linked to a widget on the UI - example some USB microphones have a "mute" button, which is not the same as a PTT button: press once to mute and press again to unmute. Others have a true PTT button - hold it down to unmute/transmit, release it to mute/stop transmission
* USB foot-switch - this may be linked to a widget on the UI - example
* VOX (voice detection)
 
----hamlib----
 
Many commercial transceivers have some sort of serial/USB/network control interface.
The hamlib project collects the low-level protocol details and provides a high level
abstraction layer. In addition to PTT logic, hamlib handles frequency and mode control, and received signal strength reports.
HID-PTT
 
The modified USB sound card interfaces are popular with the AllStar network
(Using Asterisk to add VOIP linking to repeaters). Recent hamlib should know about HID-PTT too.
[http://images.ohnosec.org/usbfob.pdf DIY] , or buy a URI from [http://www.dmkeng.com/ DMK Engineering]


== Connecting power amplifier and antenna ==
== Connecting power amplifier and antenna ==

Revision as of 06:59, 19 March 2017

HardwareTransceiver

This page concerns the hardware issues for a transceiver. The software design is explained by existing documentation about receiver and transmitter flow graphs.

Half or full duplex

It is necessary to decide whether you want half-duplex or full-duplex

Full-duplex is more complicated, especially if using a single antenna on the same band for transmit and receive.

Transmitter activation (PTT switches, etc)

When building a transmitter or transceiver, there are various ways to start and stop transmission.

  • always on - as long as the application is running, transmission occurs continuously.
  • widget - using the mouse or keyboard to control a widget on the user interface
  • USB microphone with PTT switch - this may be linked to a widget on the UI - example some USB microphones have a "mute" button, which is not the same as a PTT button: press once to mute and press again to unmute. Others have a true PTT button - hold it down to unmute/transmit, release it to mute/stop transmission
  • USB foot-switch - this may be linked to a widget on the UI - example
  • VOX (voice detection)

hamlib----

Many commercial transceivers have some sort of serial/USB/network control interface. The hamlib project collects the low-level protocol details and provides a high level abstraction layer. In addition to PTT logic, hamlib handles frequency and mode control, and received signal strength reports. HID-PTT

The modified USB sound card interfaces are popular with the AllStar network (Using Asterisk to add VOIP linking to repeaters). Recent hamlib should know about HID-PTT too. DIY , or buy a URI from DMK Engineering

Connecting power amplifier and antenna

Based on these comments

  1. use an RX/TX path switch (only for half-duplex)
    • USRP example: control it using the USRP device's GPIO pins
  2. use a circulator (more expensive solution, suitable for full-duplex though)

Amplifier vendors:

  • Kuhne make some interesting power amplifiers that can take the low power signal from an SDR (typically 100mW or less) up to the desired level.