Peak Detector2

From GNU Radio
Revision as of 14:13, 9 March 2021 by Duggabe (talk | contribs) (add example flowgraph and output)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Detect the peak of a signal.

If a peak is detected, this block outputs a 1, else it outputs 0's. A separate debug output may be connected, to view the internal estimated mean described below.

Parameters

(R): Run-time adjustable

TH factor rise (R)
Determines when a peak is present. An average of the input signal is calculated (through a single-pole autoregressive filter) and when the value of the input signal goes over threshold_factor_rise*average, we assume we are in the neighborhood of a peak. The block will then find the position of the maximum within a window of look_ahead samples starting at the point where the threshold was crossed upwards.
Look ahead (R)
Used when the threshold is found to look if there another peak within this step range.
Alpha (R)
One minus the pole of a single-pole autoregressive filter that evaluates the average of the input signal.

Example Flowgraph

This flowgraph can be found at [1].

Peak detector2 fg.png

Example Output

Peak detector2 out.png

Source Files

C++ files
TODO
Header files
TODO
Public header files
TODO
Block definition
TODO