Polyphase Interpolator

From GNU Radio
Revision as of 04:14, 15 July 2019 by 777arc (talk | contribs) (Created page with "Category:Block Docs This block takes in a signal stream and performs interger up-sampling (interpolation) with a polyphase filterbank. The first input is the integer speci...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

This block takes in a signal stream and performs interger up-sampling (interpolation) with a polyphase filterbank. The first input is the integer specifying how much to interpolate by. The second input is a vector (Python list) of floating-point taps of the prototype filter.

The filter's taps should be based on the interpolation rate specified. That is, the bandwidth specified is relative to the bandwidth after interpolation.

For example, using the GNU Radio’s firdes utility to building filters, we build a low-pass filter with a sampling rate of , a 3-dB bandwidth of and a transition bandwidth of . We can also specify the out-of-band attenuation to use, ATT, and the filter window function (a Blackman-harris window in this case). The first input is the gain, which is also specified as the interpolation rate so that the output levels are the same as the input (this creates an overall increase in power).

The PFB interpolator code takes the taps generated above and builds a set of filters. The set contains number of filters and each filter contains ceil(taps.size()/interp) number of taps. Each tap from the filter prototype is sequentially inserted into the next filter. When all of the input taps are used, the remaining filters in the filterbank are filled out with 0’s to make sure each filter has the same number of taps.

Parameters

Interpolation
Specifies the interpolation rate to use
Taps
The prototype filter to populate the filterbank. The taps should be generated at the interpolated sampling rate.
Attenuation
Stop band attenuation
Sample Delay
Underlying filter's sample delay