Difference between revisions of "Throttle"

From GNU Radio
Jump to navigation Jump to search
 
Line 16: Line 16:


; Vec length
; Vec length
  Default value = 1  
: Default value = 1  


; Ignore rx_rate tag
; Ignore rx_rate tag

Latest revision as of 11:48, 13 January 2022

Throttle flow of samples such that the average rate does not exceed the specific rate (in samples per second).

A throttle block should be used if and only if your flowgraph includes no rate limiting block, which is typically hardware (e.g., an SDR, speaker, microphone). It is not intended nor effective at precisely controlling the rate of samples. That should be controlled by a source or sink tied to sample clock. E.g., a USRP or audio card.

The Throttle Block is typically attached directly to the output of a non-hardware source block (e.g. Signal Source), in order to limit the rate at which that source block creates samples.

Parameters[edit]

(R): Run-time adjustable

Type
Data type of the block can be complex, float, int, short or byte. Default value is complex.
Sample rate(R)
Maximum average sample rate desired.
Vec length
Default value = 1
Ignore rx_rate tag
If set to False, the block will set its sample rate to the value of recieved tags with the key rx_rate. It will ignore other tags.

Example Flowgraph[edit]

In this example flowgraph, if you remove the Throttle block, the output will look the same, but your CPU will be at 100% and GNU Radio might crash.

Signal-source-ex.png

Source Files[edit]

C++ files
Here
Header files
Here
Public header files
Here
Block definition
Yaml