VCO: Difference between revisions
Jump to navigation
Jump to search
(Created page with "Category:Block Docs Category:Stub Docs This is the template for the "Page-per-block Docs". This first section should describe what the block...") |
(add reference to gr-RTTY-basics; revise flowgraph) |
||
(6 intermediate revisions by 2 users not shown) | |||
Line 1: | Line 1: | ||
[[Category:Block Docs]] | [[Category:Block Docs]] | ||
VCO - Voltage controlled oscillator. Produces a sinusoid of frequency based on the amplitude of the input. See [[VCO (complex)]] for a complex sinusoidal output. | |||
input: float stream of control voltages; | |||
output: float oscillator output | |||
== Parameters == | == Parameters == | ||
( | ; Sample Rate | ||
: sampling rate (Hz) | |||
; | ; Sensitivity | ||
: | : units are radians/sec/volt | ||
; | ; Amplitude | ||
: | : output amplitude | ||
== Example Flowgraph == | == Example Flowgraph == | ||
This flowgraph can be found at [https://github.com/duggabe/gr-RTTY-basics/tree/master/RTTY_xmt] | |||
[[File:RTTY_vco_fg.png]] | |||
For this flowgraph, the standard RTTY tones of 2295 (mark) and 2125 (space) are generated. The calculations for this follow: | |||
* Choosing a full-scale frequency of 2500Hz with an input of +1, the VCO Sensitivity = (2 * Pi * 2500 / 1) = 15708 | |||
* The space frequency of 2125 is created by vco_offset = (2125 / 2500) = 0.850 volts | |||
* The mark frequency of 2295 is created by a vector of (1 * 0.068) + 0.850 = 0.918 volts | |||
See [[Sample_Rate_Tutorial#Sink_hardware_example]] for a discussion of the timing involved in a similar flowgraph. | |||
== Source Files == | == Source Files == | ||
; C++ | ; C++ files | ||
: [https://github.com/gnuradio/gnuradio TODO] | : [https://github.com/gnuradio/gnuradio TODO] | ||
Revision as of 10:57, 2 September 2020
VCO - Voltage controlled oscillator. Produces a sinusoid of frequency based on the amplitude of the input. See VCO (complex) for a complex sinusoidal output.
input: float stream of control voltages;
output: float oscillator output
Parameters
- Sample Rate
- sampling rate (Hz)
- Sensitivity
- units are radians/sec/volt
- Amplitude
- output amplitude
Example Flowgraph
This flowgraph can be found at [1]
For this flowgraph, the standard RTTY tones of 2295 (mark) and 2125 (space) are generated. The calculations for this follow:
- Choosing a full-scale frequency of 2500Hz with an input of +1, the VCO Sensitivity = (2 * Pi * 2500 / 1) = 15708
- The space frequency of 2125 is created by vco_offset = (2125 / 2500) = 0.850 volts
- The mark frequency of 2295 is created by a vector of (1 * 0.068) + 0.850 = 0.918 volts
See Sample_Rate_Tutorial#Sink_hardware_example for a discussion of the timing involved in a similar flowgraph.
Source Files
- C++ files
- TODO
- Header files
- TODO
- Public header files
- TODO
- Block definition
- TODO