ZMQ PUB Sink

From GNU Radio
Revision as of 00:20, 13 April 2020 by Duggabe (talk | contribs) (add example flowgraph)
Jump to navigation Jump to search

Sink the contents of a stream to a ZMQ PUB socket.

This block acts a a streaming sink for a GNU Radio flowgraph and writes its contents to a ZMQ PUB socket. A PUB socket may have subscribers and will pass all incoming stream data to each subscriber. Subscribers can be either another gr-zeromq source block or a non-GNU Radio ZMQ socket.

Parameters

(R): Run-time adjustable

Address
ZMQ socket address specifier. The format of the address is tcp://*:port where * should be 127.0.0.1 for localhost.
Note: If the Source and Sink blocks are on two different computers on the same LAN, then the IP and port number of the Sink block must be specified on each end of that connection. For example, if the Sink is on IP 192.168.2.14:5678 and the Source is on IP 192.168.2.5, both Source and Sink blocks must specify the Sink IP and port (192.168.2.14:5678).
Timeout
Receive timeout in milliseconds, default is 100ms.
Pass Tags
Whether sink will serialize and pass tags over the link.
High Watermark
High Watermark to configure the socket to (-1 => zmq's default)

Example Flowgraph

This flowgraph is a simulation of an Amplitude Modulation transmitter. It is sending the transmit signal to a ZMQ PUB Sink data socket connected to the receiver section.

AM transmit fg.png

Source Files

C++ files
TODO
Header files
TODO
Public header files
TODO
Block definition
TODO