Audio Sink

From GNU Radio
Revision as of 02:10, 30 October 2019 by Duggabe (talk | contribs) (revised Parameters section)
Jump to: navigation, search

Allows a signal to be played through your speakers or other audio device


Sample Rate

To set the Audio sampling rate, click the drop-down menu to see popular rates. Note: not all sampling rates will be supported by your hardware. For typical applications, this should be set to 48kHz.

Device Name

Leave the device name blank to choose the default audio device. Other typical choices include:

  • pulse
  • hw:0,0
  • plughw:0,0

For ALSA users with audio trouble, follow this procedure:

  • from a terminal window enter:

aplay -L

  • find the entry such as:
       USB Audio Device, USB Audio
       Direct hardware device without any conversions

      from the list which matches your device.

  • use the first line of that entry (e.g. "hw:CARD=Device,DEV=0") as the device name (without the quotes).

OK to Block

On by default, which should be used when this sink is not throttled by any other block.

Num Inputs

The audio sink can have multiple inputs depending upon your hardware. For example, set the inputs to 2 for stereo or 1 for mono.

Example Flowgraph

This flowgraph should play a 1 kHz tone out of your speakers. Note that you don't need a throttle block, the Audio Sink should throttle for you. If you do end up using an already-throttled signal source, then set "OK to Block" to No.